CTR2-Flex firmware has been renamed to CTR2-Dial as of November 15, 2026. This change was made to reduce the confusion caused when I combined CTR2-Dial and CTR2-Flex firmwares into a single package. This change aligns the firmware with CTR2 units based on the M5Dial.
This firmware is essentially the same as the dual-boot CTR2-Flex v2.0 firmware, except instead of referring to MIDI and Flex WiFi modes as “CTR2-Dial” and “CTR2-Flex”, they are now simply referred to as MIDI and Flex modes.
v3.0 firmware also adds support for the new CTR2 Relay feature that has been added to AetherSDR. This feature allows your CTR2-Dial based controller to connect directly to your Flex radio using USB, through the CTR2 Relay interface. The Flex mode manual below explains this new feature.
CTR2-Dial v3.0 MIDI mode supports a new Controls menu for CTR2-Quad hardware. This menu allows you to assign dial controls and buttons to the hardware knobs, knob switches, and pushbuttons on the unit.