CTR2-Dial Encoder Interface

Buy encoder interfaces separately if you want to build a CTR2-Dial using your own M5Dial and enclosure. Each interface includes voltage divider circuits to reduce the 5V input voltage supplied by the M5Dial down to 3.3 volts for use on the M5Dial’s input pins. Each encoder is supplied with a wiring harness that simply plugs into the M5Dial’s I/O port.

You can choose from either no-detent (smooth) or detent (bumpy) encoder types.

You can also choose either a 32mm aluminum knob (great for single-encoder CTR2-Dial with a 3.5mm paddle jack) or a 15mm knob if you want smaller knobs for the dual-encoder model.

You can build your own paddle interface using the schematics found here.

NOTE: The CTR2-Dial firmware license is not included with the purchase of this item. It must be purchased separately.

Visit the CART page for more payment options.